BandMask_A2-1_Annual.pdf

This inspection and maintenance should be performed at least annually and as dictated by condition revealed during daily/monthly inspection. Monthly inspections determine Necessity for overhaul with more accuracy than simply placing a number of hours of use. Read More

BandMask_A2-2_Monthly.pdf

This inspection is the minimum recommended maintenance and should be performed at least ONCE A MONTH with Mask(s) in continuous use (used for more than 20 diving days in a month) or at least every TWO (2) MONTHS, with Mask(s) used less than 10 diving days a month. Read More

BandMask_A2-3_Daily.pdf

These are recommended minimum checks when using Kirby Morgan KMB 18/28 Band Masks. Additional checks may be required as dictated by the conditions and tasks being performed. Failure to perform in-water checks may result in serious injury or death. Read More

BandMask_A2-4_Pre-Dive.pdf

Helmet(s) being used in polluted waters, or extreme environments, will require more frequent inspection... KMDSI strongly recommends the use of a Tender to assist the diver when “dressing-in”. The Tender should ensure the Helmet Liner is fastened to the Helmet Shell and the Chinstrap is properly fastened under the divers chin, once the Helmet is donned. Prior to closing the Yoke/Neck Clamp Assembly, ensure that the Clamp is installed. Read More

BandMask_A2-5_In-Water.pdf

During removal of components for inspection, O-rings and other consumable items may be reused, providing they are clean and a visual inspection does not reveal any damage or deterioration... If diving is conducted with less than the minimum recommended supply pressure, the diver must tailor the work to prevent exhaustion. Read More

BandMask_A2-6_Post-Dive.pdf

This cleaning and maintenance schedule is recommended to be performed on a DAILY basis... Detailed instructions are located in Chapter 5. Read More